9
lights in red with the word CALL showed intermittently and the number associated with
the wireless beltpack that is calling at this time (if the call is from the base station does
not indicate any number associated); if the vibrator is enabled (see vibrator on/off
section for more information) will be vibrate; if the buzzer is enabled (see buzzer on/off
section for more information) an intermittent sound takes place during about three
seconds, the same as in all the units (wireless beltpacks, beltpacks, base stations, desk
stations, master stations, etc.), connected to the same intercom channel.
If the CALL switch is pressed continuously, the duration of the call signal will be
higher (the time that the switch is pressed, and approximately 3 seconds more).
If a call signal is generated in an external unit (wireless beltpacks, beltpacks, base
stations, desk stations, master stations, etc.), the LED associated with the CALL switch
will start blinking, the OLED display lights in red with the word CALL showed
intermittently and the number associated with the wireless beltpack that is calling at this
time (if the call is from the base station does not indicate any number associated), if the
vibrator is enabled (see vibrator on/off section for more information) will be vibrate, and
if the buzzer is enabled (see buzzer on/off section for more
information) an intermittent sound will take place during about three
seconds.
3.6 OLED DISPLAY
The wireless beltpack has a colour OLED display of 96x64 pixels to
show the messages and the configuration of the unit at a glance.
The display, in idle mode, indicating the base station
coverage , the time that the beltpack remain on ,
the battery level of the trunk , if it is on the
microphone , phantom power ,
microphone extra gain , buzzer , the
registration number of the beltpack , the name of the
beltpack , the beltpack selected channel , the vibrator and the volume level of
the headphones .
After thirty seconds of inactivity, the display and the LEDs of the wireless beltpack,
lower its brightness to save power, and after another thirty seconds the display goes off
and the LEDs down light intensity again.
If you press any key, receive a call or plug the wireless beltpack charger, the display
will switch back on and the LEDs will return to their scheduled light intensity.
3.7 MENU SWITCH
When the MENU switch is pressed and there isn't active any message on
the wireless beltpack, appears the menu of the beltpack, with which
various parameters of the beltpack can be configured. If any beltpack
message or the beltpack menu are active, the system return to normal mode.
When the beltpack menu is activated, the VOLUME switches
move the cursor up/down the options, the MENU
WBP-212 WIRELESS DUAL CHANNEL MANAGER
(12 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais