Altair EF-202 Guia de Resolução de Problemas Página 18

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 17
18
correspond to another system.
c) When beltpack comes from a service, it is possible that the
registers are changed so it is necessary to register the whole system
again. Refer to manual.
3) Beltpack switch off
immediately after switch
on.
a) Batteries are low. Check battery status. Charge it.
4) Beltpack refuse to
switch off.
a) Reset the beltpack with the reset switch.
5) Poor charge. a) Disconnect the charger and try it again. Check charge time to be
around 4 hours.
6) Suddenly Beltpack
switch off. Very sensitive
to lateral strikes.
a) Base unit has been switched off or base out of range.
b) Batteries can be low, check beltpack battery status. Charge it if
necessary.
7) Charger led always is
green when charging.
a) Check charger plug contacts. Try with another plug. Try to charge
another beltpack verifying charger.
b) Batteries are so low that the unit is not able to start charging. Wait
for 10 minutes connected on charger and try it again.
8) Unit refuse to charge
after a long period of not in
use.
a) Wait for 10 minutes connected on the charger to verify charging
normally.
9) Bad coverage in some
areas.
a) Try another better position of the base unit.
b) Study the possibility of installing a higher gain directional antenna
on the base unit.
10) Mic or headphone
failure.
a) Check volume or mic gain settings.
b) Check beltpack with another headset.
11) Mic failure. a) When using headsets with electret microphones it is necessary to
enable the phantom power and configure mic gain accordingly. Refer
to the manual.
12) Vibrator does not run. a) Press simultaneously Mic and Select keys to activate it.
13) Buzzer does not work. a) Check the base station is on Buzzer Kill mode
WBP-212 WIRELESS DUAL CHANNEL MANAGER
Vista de página 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23

Comentários a estes Manuais

Sem comentários