15
sure to delete the register, and once confirmed the register will be deleted
immediately, or turning on the beltpack pressing the ON/OFF switch maintaining
pressed the MENU and the SELECT switches, the beltpack will start normally, but
when it is connected to the base station, this one will be reset and the beltpack will be
deregistered. We can cancel the deregistration procedure, before the wireless
beltpack connect with the base station, by pressing the MENU (ESCAPE) switch.
If the procedure fails, turn off the base station and the beltpack and start again.
3.8 ON/OFF SWITCH
When the beltpack is power off, and the beltpack’s ON/OFF switch it is
pressed and hold for two seconds, all the beltpack LEDs light on and last a
little while it will sound the buzzer (if buzzer is turn on) and will vibrate (if the
vibrator is turn on), and the display will turn on, indicating that it is operative.
If the base on which it is registered finds within its range, the ON/OFF switch LED
will begin to blink, the base station range indicator in the display will stop
to blink and the audio will be opened. At this moment you can begin to use your ALTAIR
WBP-212 wireless beltpack.
To turn off the beltpack, press and hold two seconds the ON/OFF switch when the
beltpack is turned on. In this moment will sound the buzzer (if the
buzzer is turn on), a GOODBYE message appears in the display and
when the ON/OFF switch it is depressed, the beltpack it is turned off.
If the wireless beltpack is turned on, and you press the
ON/ OFF button for a while, the beltpack shows the battery
status.
The battery level indicator is displayed by default in
the display: .
3.9 VOLUME UP/DOWN SWITCHES
The volume switches allows attenuating or amplifying
the signal sent to the headphones. This switches adjusts the
listen level to the headphones as you wish.
When volume UP/DOWN switches are pressed, appears in the OLED display
the volume level indication allow us change this volume level. There are 10
steps of volume (1-10), and this is indicated in the OLED display with the
next icon: .
The VOLUME, it is stored in the unit.
FACTORY PRESET: 7.
3.10 SELECT SWITCH
This switch , in normal mode, enables/disables the
buzzer sound when the unit receives a call and when the user press a key.
Whenever this switch is pressed, and the buzzer is enabled, it will be disabled, and the
LED indicator will turn off. On the other hand, if the buzzer was disabled, it will be
enabled and the LED indicator will lighten up, and appears this icon in the display.
WBP-212 WIRELESS DUAL CHANNEL MANAGER
(12 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais