Altair EF-202 Guia de Resolução de Problemas descarregar pdf (Página 19)

7.1 CHANGING THE FUSE

The battery charger ALTAIR WBPC-200 is set to operate from 100 VAC, 50-60Hz to

240VAC, 50-60Hz.

Make sure that the unit is disconnected of the mains.

In the unit rear panel, is placed the mains connector, and the fuse holder. The box

bellow this mains connector is called fuse holder. Take out the fuse holder.

Upon extracting the fuse holder, the fuse will appear, take out it

and change for the new one.

Insert the fuse holder into the mains connector again.

Make sure that the fuse is the right one for the selected voltage:

FUSE

T2A/250VAC.

CAUTION: Always make sure upon changing the fuse, that this is the adequate for the

selected mains voltage (T2A/250VAC).

7.2 CONNECTING TO THE MAINS

The connection of the battery charger ALTAIR WBPC-210 power supply

to the mains takes place by the cord included in the box.

Make sure that the beltpack are disconnected from the battery charger.

Insert the female I.E.C. connector of the tripolar cable into the unit

power supply male connector, placed at the rear panel

Insert the male connector of the tripolar cable into the mains plug.

1 2 ... 14 15 16 17 18 19 20 21 22 23

Sem comentários

Altair EF-202 Guia de Resolução de Problemas Página 19