7
Press and hold the Channel Select switch and when the AB lamps flashes (wait 2 seconds),
start your message from the headset microphone. When done, release the switch.
On the WBS-202 base station, the front panel SA led will glow for the time you are depressing
this switch and the message is carried out from the SA output to the external PA equipment. This
function is very useful for timing events, fire alarms, or general announces.
Intercom mic signal is not interrupted in this mode and remains in the selected channel.
3.5 CALL SWITCH
When this switch is pressed, a call
signal is sent to the system and to the
intercom channel in which it is connected
the base station. The call signal makes the LED
associated with the switch to start blinking; the OLED
display lights in red with the word CALL showed
intermittently and the number associated with the
wireless beltpack that is calling at this time (if the call is
from the base station does not indicate any number
associated); if the vibrator is enabled (see vibrator on/off section for more information) will be
vibrate; if the buzzer is enabled (see buzzer on/off section for more information) an intermittent
sound takes place during about three seconds, the same as in all the units (wireless beltpacks,
beltpacks, base stations, desk stations, master stations, etc.), connected to the same intercom
channel.
If the CALL switch is pressed continuously, the duration of the call signal will be higher (the
time that the switch is pressed, and approximately 3 seconds more).
If a call signal is generated in an external unit (wireless beltpacks, beltpacks, base stations,
desk stations, master stations, etc.), the LED associated with the CALL switch will start blinking, the
OLED display lights in red with the word CALL showed intermittently and the number associated
with the wireless beltpack that is calling at this time (if the call is from the base station does not
indicate any number associated), if the vibrator is enabled (see vibrator on/off section for more
information) will be vibrate, and if the buzzer is enabled (see buzzer on/off section for more
information) an intermittent sound will take place during about three seconds.
3.6 OLED DISPLAY
The wireless beltpack has a colour OLED display of 96x64 pixels to show the
messages and the configuration of the unit at a glance.
The display, in idle mode, indicating the base station coverage , the
time that the beltpack remain on , the battery level of the trunk , if it is on the
microphone , phantom power , microphone extra gain , buzzer , the
registration number of the beltpack , the name of the
beltpack , the beltpack selected channel the vibrator and
the volume level of the headphones .
After thirty seconds of inactivity, the display and the LEDs of the wireless beltpack, lower its
brightness to save power, and after another thirty seconds the display goes off and the LEDs down
light intensity again.
If you press any key, receive a call or plug the wireless beltpack charger, the display will
switch back on and the LEDs will return to their scheduled light intensity.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK
(19 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais