Altair WBP-200 Guia de Resolução de Problemas Página 14

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 13
14
4. SPECIAL OPERATIONS
In order to set-up some of the wireless beltpack possibilities, the unit must be opened removing
the bottom auxiliary cover, removing a screw.
NOTE: This type of operations takes place with the unit is opened; the best thing should be to carry it
out by a qualified technician. Care must be taken to avoid short circuit between battery holders, etc.
DANGER: Before opening the unit, turn it off. Use of protective glasses when operating batteries.
CAUTION: Protect the wireless beltpack from the rain and moisture, mostly if it is open. If liquid is
spilled into the unit, disconnect it from the mains and consult a qualified service technician.
4.1 AUXILIARY BATTERY
The wireless beltpack has a battery holder to place an
alkaline battery, Ni-MH battery 2500 mA/h or lithium battery
of AA size, which gives us a range of 3/4/5 hours
respectively with the main battery discharged.
Be very careful, do not insert the battery in reverse
polarity, as it may break the circuitry of the wireless beltpack.
Always remember to remove the empty battery.
4.2 RESET BUTTON
The unit has a RESET button near the auxiliary battery
holder in order to reset the unit in case of malfunction
NOTE ON ENVIRONMENTAL PROTECTION:
After the implementation of the
European Directive 2002/96/EU in the
national legal system, the following
applies:
Electrical and electronic devices may
not be disposed of with domestic waste. Consumers are obliged by law to
return electrical an electronic devices at the end of their service lives to the
public collecting points set up for this purpose or point of sale. Details to this
are defined by the national law of the respective country.
This symbol on the product, the instruction manual or the package indicates that a product is
subject to this regulations.
By recycling, reusing the materials or other forms of utilising old devices, you protecting our
environment.
5. SPECIAL RECOMMENDATIONS
Don’t place the unit in close proximity to metallic surfaces and/or other electronic equipment in
order to avoid interferences.
In case of lose of range, reorient your body position to face up the base unit position.
Take special attention to the placement of the base station when trying to reach all the possible
placements of the beltpacks specially when concrete walls or other absorbing materials are in
between.
In order to have the units ready to operate, it is a good practice to make a full charge of all the
units every two month.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK
Vista de página 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários