6
3.2 MIC ON/OFF/PUSH TO TALK SWITCH (TALK)
The MIC switch allows to enable/disable the
microphone, so that we are able to speak with other
units connected to the same intercom channel.
If the microphone is activated, its associated LED will light up and this icon, will show in the
display: ,and on the other hand, if it is disabled, its associated LED will turn off and will not
show the icon in the display.
The MIC switch has two operation modes. When this switch is pressed quickly the microphone
changes its state, if it was enabled, upon being pressed it gets disabled and turns off the
associated LED, and if it was disabled, upon being pressed gets enabled and turns on the
associated LED.
When the MIC switch is pressed and held, the unit will enter in the special function PUSH TO
TALK, this means that the microphone will be enabled until the switch is released.
The unit provides a MIC-KILL (turns off the MIC) system, so that when the mic is enabled it is
possible to muted it by the MIC-KILL function of the base station ALTAIR WBP-200 or a master station
EF-200, connected to the base station. This MIC-KILL system is compatible with other intercom
systems of the market.
The state of the MIC (on/off), it is stored in the unit.
3.3 VOLUME UP/DOWN SWITCHES
The volume switches allows attenuating or amplifying the signal sent to
the headphones. This switches adjusts the listen level to the headphones as
you wish.
The beltpack has two volume switches pairs, one pair in the upper panel: and the
other on the front panel: the four buttons perform the same function. When
volume UP/DOWN switches are pressed, appears in the OLED display
the volume level indication allow us change this volume level. There are 10 steps of
volume (1-10), and this is indicated in the OLED display with the next icon: .
The VOLUME, it is stored in the unit.
FACTORY PRESET:
7.
3.4 CALL SWITCH
When this switch is pressed, a call
signal is sent to the system and to the
intercom channel in which it is connected
the base station. The call signal makes the LED
associated with the switch to start blinking; the OLED
display lights in red with the word CALL showed
intermittently and the number associated with the
wireless beltpack that is calling at this time (if the call is
from the base station does not indicate any number
associated); if the vibrator is enabled (see vibrator on/off section for more information) will be
vibrate; if the buzzer is enabled (see buzzer on/off section for more information) an intermittent
sound takes place during about three seconds, the same as in all the units (wireless beltpacks,
beltpacks, base stations, desk stations, master stations, etc.), connected to the same intercom
channel.
If the CALL switch is pressed continuously, the duration of the call signal will be higher (the
time that the switch is pressed, and approximately 3 seconds more).
If a call signal is generated in an external unit (wireless beltpacks, beltpacks, base stations,
desk stations, master stations, etc.), the LED associated with the CALL switch will start blinking, the
OLED display lights in red with the word CALL showed intermittently and the number associated
WBP-210 SINGLE CHANNEL WIRELESS BELTPACK
(16 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais