10
lock the keys configured in the keyboard lock configuration (see section 3.6.10) TOP Panel, FRONT
panel or all.
The keyboard lock can be enabled via the appropriate menu, or directly without accessing
the beltpack menu, pressing the ON/OFF switch, and at the same time the MIC ON/OFF
switch (changing the vibrator state, if it is on, turn to off mode and if the vibrator
it is turned off, turn to on mode). It can only be disable by pressing the
ON/OFF switch, and at the same time the MIC ON/OFF switch unless the keyboard lock
configuration will be only the TOP panel keys, in which case it can be disabled by menu.
Whenever the keyboard will be locked, the following icon appears on the display: .
3.6.12 TWIN MODE
Twin mode allows any two wireless beltpacks to talk
privately between them. In order to keep the conversation
between two wireless beltpacks, the two beltpacks with witch we want to talk between privately,
must be configured in TWIN mode, and wait a few seconds they find one to the other, then starts
a private conversation between the two beltpacks.
The beltpack configured in TWIN mode lock for another beltpack in configured in TWIN
mode, and set a private communication with the first one it finds.
In TWIN mode don't work the CALL switches, and the base station
coverage.
This TWIN operating mode do not need wireless base station.
We can enter or leave this TWIN operation mode through the menu, or
pressing at the same time the ON/OFF switch and the front panel VOLUME UP
switch.
3.6.13 STAND BY MODE
In this mode, the beltpack can receive CALLs, but the audio it
is disconnected. This mode is useful to save battery, since the
beltpack consumes 5 times less than in full duplex state.
We can enter this STAND BY mode through the menu, or pressing at the same time
the ON/OFF switch and the front panel VOLUME DOWN switch.
To exit from STANDBY mode, press the ON/OFF switch briefly.
3.6.14 BELTPACK REGISTRATION
Each beltpack can be registered in two different base stations,
so that if it loses the range of one, changes the operation to the other
base station. Each base station can register a maximum of four
beltpacks. See the WBS-200 owners manual for details.
With the base station turned on, press and hold the REGISTER base station switch during six
seconds. At this moment the base station will sound (if the buzzer is turned on) and will blink the
IN-RANGE (1-2-3-4) leds corresponding where is going away to register the new beltpack. If the
base station has registered four beltpacks already, the function will be reset, and new beltpacks
will not be able to be registered until the deregistration of some
beltpack is made or deregister all the beltpacks registered in the
base station (consult the base station WBS-200 manual for
more information).
If we do not do anything during 60 seconds the function
will be reset.
WBP-210 SINGLE CHANNEL WIRELESS BELTPACK
(16 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais