8
WBP-200 SINGLE CHANNEL WIRELESS BELTPACK.
BELTPACK REGISTRATION
Each beltpack can be registered in two different base stations, so that if it loses the range of
one, changes the operation to the other base station. Each base station can register a maximum of
four beltpacks. See the WBS-200 owners manual for details.
With the base station turned on, press and hold the REGISTER base station switch during six
seconds. At this moment the base station will sound (if the buzzer it is turned on) and will blink the IN-
RANGE (1-2-3-4) leds corresponding where is going away to register the new beltpack. If the base
station has registered four cases already, the function will be reset, and new beltpacks will not be
able to be registered until the deregistration of some beltpack is made or deregister all the beltpacks
registered in the base station (consults the base station WBS-200 manual for the more information).
If we do not do anything during 60 seconds the function will be reset.
If we pressed key REGISTER again the function will be reset.
With the beltpack that we want to register turned off, turn on pressing the ON/OFF
switch maintaining pressed the VOLUME UP/DOWN switches (to
register it in base 1) or maintaining pressed the VOLUME UP/DOWN and the
BUZZER ON/OFF switches (to register it in base 2).
If everything goes well, the base station base will sound (if the
buzzer it is turned on) and the beltpack also (if the buzzer it is turned on), the
corresponding base station IN RANGE led will turn on and the beltpack IN RANGE led begin to blink.
If the procedure fails, turn off the base station and the beltpack and start again.
BELTPACK DEREGISTRATION
With the base station turned on, and the beltpack that is wanted to deregister
turned off, turn on the beltpack pressing the ON/OFF switch maintaining pressed the
MIC ON/OFF and the BUZZER ON/OFF switches.
The beltpack will start normally, but when it is
connected to the base station, this one will be reset and the
beltpack will be deregistered.
If the procedure fails, turn off the base station and the beltpack and start again.
DC-IN CONNECTOR
The three NiMh, AAA, 900 mA/h batteries of the wireless beltpack must be charged with the
ALTAIR WBPC-200 charger by the DC-IN connector. The polarity is tip positive.
Charging time is three hours with the batteries empty. After this 2-3 hours time, the charger sets
to trickle (maintenance) mode and can be left alone in the charger. For a full charge, it is
recommended a 2 hours minimum charging in this state.
The estimated battery life, in full duplex mode is 10 hours and 50 hours in standby mode, with
full charged batteries.
The included NiMh batteries has a shelf discharging time around 2 month. So it is imperative to
check the battery status before use:
switch ON the unit and then, press shortly the ON switch
. As a
general rule, charge the unit before using the system.
4. SPECIAL OPERATIONS
In order to set-up some of the wireless beltpack possibilities, the unit must be opened removing
the two external screws of its rear panel.
(23 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais