5
BP-200 SINGLE CHANNEL WIRELESS BELTPACK.
Once turn on the base station, push the on/off switch of the beltpack. All
the beltpack leds light on and last a little while it will sound the buzzer (if buzzer
is turn on) and will vibrate (if the vibrator is turn on), indicating that it is
operative.
If the base on which it is registered finds within its reach, the LED of IN RANGE
will begin to blink and the audio will be opened. At this moment you can begin to use
your beltpack ALTAIR WBP-200.
If the beltpack ALTAIR WBP-200 remains turned on during a period of ten minutes
without connection to the base station (the base station is turned off, outside range, or the
beltpack is not registered to any base station), it will be turned off automatically.
HEADSET CONNECTION
A TINY Q-G type connector allows to connect a headset and a microphone to the
beltpack. The headset impedance must be of 200 or higher (up to 2 K) and the
microphone may be dynamic or electret type.
For the electret microphone type is necessary to enable the phantom power of 9 VDC
with an internal preset. In order to obtain more information, consult the special operation
section.
The next list shows the XLR pins correspondence:
HEADSET
PIN 1
0 V (MICROPHONE)
PIN 2
SIGNAL (MICROPHONE)
PIN 3
0 V (HEADPHONES)
PIN 4
SIGNAL (HEADPHONES)
NOTE: Headphones could be with a double or single muff. In case of using a double muff
headphone, the two speakers should be wired in parallel mode.
CALL SWITCH
When this switch is pressed, a call signal is sent to the system and
to the intercom channel in which it is connected the base station. The
call signal makes the LED associated with the switch to start blinking; if the
vibrator is enabled (see vibrator on/off section for more information) will be vibrate; if the
buzzer is enabled (see buzzer on/off section for more information) an intermittent sound takes
place during about three seconds, the same as in all the units (wireless beltpacks, beltpacks,
base stations, desk stations, master stations, etc.), connected to the same intercom channel.
The IN RANGE led of the base station correspondent to the register number of the
beltpack will be blink. In the wireless beltpacks will be turn on the associated led with the
wireless beltpack that it is calling (LOW BAT – 1, BUZZ ON/OFF – 2, MIC ON/OFF – 3, IN
RANGE – 4). If the call is generated by the base station, all associated led will be turn off.
If the CALL switch is pressed continuously, the duration of the call signal will be higher
(the time that the switch is pressed, and approximately 3 seconds more).
If a call signal is generated in an external unit (wireless beltpacks, beltpacks, base
stations, desk stations, master stations, etc.), the LED associated with the CALL switch will
start blinking, if the vibrator is enabled (see vibrator on/off section for more information) will be
vibrate, and if the buzzer is enabled (see buzzer on/off section for more information) an
intermittent sound will take place during about three seconds.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais